analog sets not working with ABC-F

gundam · Post by **gundam** » 30 Oct 2004 23:57

Hi All,

Any1 run into this issue before:

2 PCX nodes (e25041h) connected together via ABC-F (T1 CCS)

Outside Calls entered from node 1 and is routed to node 2.

Calls to digital phone go to node 2 without issue, but calls to any Analog set drops immediate after the call setup.

From t3 trace I see the call set does go across the ABC-F.

For now, to get around the problem I setup a Ghost Z and have it immediate forward to the analog set.

Any idea what is wrong?

Post by **vad** » 31 Oct 2004 23:06

Incoming trunk group present on node 1 and node 2. Do you have the same NPD decleared in TG/NPD selector on both sides?

gundam · Post by **gundam** » 21 Feb 2005 10:44

The issue was finally resolved by doing the following:

under /system
Ignore ISDN Fault In Mandatory EI
Ignore ISDN Cause Invalid Content

I change these from NO to Yes.