Page 1 of 1
CLI on analog trunk lines
Posted: 07 Sep 2011 01:36
by orangebusiness
how to activate cli on analog trunk lines?
system is having clidsp daughter board on trunk card.
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 01:55
by vad
external lines/ list of access - for access (in details) - check item CLIP.
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 02:07
by orangebusiness
done this,not working
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 02:34
by mujib.alu
HI,
1.Check from provider CLIP on FSK/DTMF, If DTMF convert to FSK using FSK converter also confirm the cli using ID phones.
2. check DSP Parameter for NDDI board, System > Tone detector Parameters > DSP Parameters
3.Check CLIP Signal on Shelf > Board (V23 short ring or Long)
4. restart the NDDI board
5. Consult the Docx..
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 02:37
by orangebusiness
this is OXO system,sir
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 02:41
by vad
But CLI info present? If you connect analog set to analog line (without PBX) - CLI info present on set display?
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 02:42
by orangebusiness
vad wrote:But CLI info present? If you connect analog set to analog line (without PBX) - CLI info present on set display?
cli is coming without PBX perfectly
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 02:45
by mujib.alu
yes,
It is FSK or DTMF signal..?
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 04:16
by orangebusiness
mujib.alu wrote:yes,
It is FSK or DTMF signal..?
in india this is DTMF signalling
Re: CLI on analog trunk lines
Posted: 07 Sep 2011 04:20
by mujib.alu
So you are using FSk converters..? If FSK convetret used did you check the CLI(FSK support Thomsan/Alcatel ) analog phones after the FSK converter.