CLI on analog trunk lines

[orangebusiness]

how to activate cli on analog trunk lines?
system is having clidsp daughter board on trunk card.

[vad]

external lines/ list of access - for access (in details) - check item CLIP.

[orangebusiness]

done this,not working

[mujib.alu]

HI,

1.Check from provider CLIP on FSK/DTMF, If DTMF convert to FSK using FSK converter also confirm the cli using ID phones.
2. check DSP Parameter for NDDI board, System > Tone detector Parameters > DSP Parameters
3.Check CLIP Signal on Shelf > Board (V23 short ring or Long)
4. restart the NDDI board
5. Consult the Docx..

[orangebusiness]

this is OXO system,sir

[vad]

But CLI info present? If you connect analog set to analog line (without PBX) - CLI info present on set display?

[orangebusiness]

But CLI info present? If you connect analog set to analog line (without PBX) - CLI info present on set display?

cli is coming without PBX perfectly

[mujib.alu]

yes,

It is FSK or DTMF signal..?

[orangebusiness]

yes,

It is FSK or DTMF signal..?

in india this is DTMF signalling

[mujib.alu]

So you are using FSk converters..? If FSK convetret used did you check the CLI(FSK support Thomsan/Alcatel ) analog phones after the FSK converter.