INTIP3 BOOT FAILURE

[monoestable]

hI, I can't to install the binaries on the INT-IP3 card, I have 10/100/1000 connector, I need to know if I must configure the deep shitch of the card in a specific mode, because I can't to stop the autoboot. Thanks. this is the logs:

m41t11 Chip
Initializing date and time.
Initializing CMOS contents.
Reloading default boot sequence.
Hit any key to stop autoboot: 0
Failed to mount ext2 filesystem...
** Bad ext2 partition or disk - mmc 0:1 **
Resetting the board.ý

U-Boot 1.3.0-rc3 (Sep 10 2008 - 14:34:48) 3EH30350AAAE bootl100/000.004

Reset Status: Software Hard, External/Internal Soft, External/Internal Hard

CPU: e300c4, Rev: Unknown revision number:80c70021
Warning: Unsupported cpu revision!
I2C: ready
DRAM:
DDR DIMM: data bus width is 64 bit without ECC
DDRC ECC mode: OFF
DDR RAM: 256 MB
FPGA: /soc@e0000000/gpio@c00/fpga@01f00000: FPGA4C1NV reloading... done
FLASH: 2 MB
PCI: Bus Dev VenId DevId Class Int
00 17 1064 2102 0000 00
00 18 1064 2102 0000 00
00 1d 10ee 0300 0b40 ff
In: serial
Out: serial
Err: serial
Net: TSEC0, TSEC1
eSDHC: 4bit-buswidth mode
SATA: SATA0 [Link: no RDY]
SATA1 [Link: no RDY]
## Booting image at ff836dc0 ...
Image Name: aleboot.bin
Image Type: PowerPC U-Boot Standalone Program (uncompressed)
Data Size: 8960 Bytes = 8.8 kB
Load Address: 00200000
Entry Point: 00201a2c
Verifying Checksum ... OK
OK

[alaint73]

unlike INTIP2, There is no dip switch to be set on INTIP3