Speed mode intipb

[dryhouse]

Hi Guys,

I need your help.I have this incident in my system:

12/08/10 08:57:51 000001M|001/20/-/---|=2:4408=INT-IP Ethernet error code 4 (status 1 0 0x0a4 0x00 0x00)

How can i configure speed mode parameters in this coupler (INTIPB)?

Gracias.

[murraya]

Hi, connect to the intipb console port and enter in config mode. you can set QoS, Vlan, speed, duplex etc...

[dryhouse]

How can i enter in config mode? I´ve never do it before...

Gracias brother

[murraya]

HI, when the card boots follow the below.......

When the message Hit ENTER key to suspend coupler boot processis displayed, press Enter to display the main menu:


–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
IP configuration Menu
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Available commands :
– view : display current IP configuration
– chmode : change IP Configuration Mode (Static/dynamic)
– chip : change Static IP Parameters
- chqual : Change default quality Parameters
– save : saved modified configuration
– reset : reset coupler
Use? or ? <cmd> to get help on Command
Config:

Enter chmode, then 1 to change the initialization mode to Static mode.

Enter chip and configure the following IP parameters:

The INT-IP B board IP address,

The IP subnetwork mask,

The router IP address,

The TFTP server 1 IP address,

The TFTP server 2 IP address.

Enter save to save the parameters.

[mujib.alu]

Hi,
It's very clear on Docs......System Documentation/System Seveices/Crystal Harware media gateway/Follow the INTIPB static config.....

try..!!

[dryhouse]

How can i do it without reboot? in chview command can i see it?

Gracias.