remote access

comerja · Post by **comerja** » 02 Jun 2010 06:29

Hello,

I want to access remotely my OXO. It has an indial number to do this. But in the OXO it is configured as an ISDN line.
I now want to use an analog PSTN line to remotely access the OXO. What changes should I make in the config of the OXO?
On which port do I need to connect the analog line?

Thank you!

Jan

leo · Post by **leo** » 02 Jun 2010 12:27

You need to have a APA card for interfacing the analog line. Configure the new PSTN line in OXO and manage its call distribution to an XRA port.

comerja · Post by **comerja** » 02 Jun 2010 15:06

and what is an APA card? and a XRA port?

elkiwi · Post by **elkiwi** » 03 Jun 2010 15:27

APA = Analogue Public Access
XRA = Internal modem port.

good luck!

peter68 · Post by **peter68** » 22 Jun 2010 06:06

Is the analog PSTN line connected to the OXO or is it the line from where you dial in from? You need to have an analog modem 33k6>. Configure an DID nummer to the Rmote Acc.V34 Hwa 90-001-01. Now you can remote access the OXO.

Good luck,
Peter

comerja · Post by **comerja** » 23 Jun 2010 12:53

it isn't connected yet. how do I make the connection between the modem and the OXO? is it a serial connection?
thank you very much!

leo · Post by **leo** » 23 Jun 2010 13:10

OXO has a built in modem so no need for an external modem. Just manage the call distribution of analog PSTN line, connected to an APA port, to the XRA edn number.
You may test this by dialing internally the XRA edn number from any users extension..the internal modem would answer.
Hope this helps.

LEO

20deoctubre · Post by **20deoctubre** » 03 Aug 2011 10:34

Just a quick question...
Are this configuration the same for an E1?

Alcatel Unleashed

remote access

remote access

Re: remote access