IAP 105 - Issue to remote access Virtual Controller

Also known as OmniAccess Instant AP
Post Reply
abrazioli

IAP 105 - Issue to remote access Virtual Controller

Post by abrazioli »

Hi everyone.

We have bouth 2 Alcatel AP's 105 and we cannot access the IP of Virtual controller. It works only when I'm on the same vlan as the Controller IP. But our users do not stays on the management Vlan.

Do anyone know how to configure a gateway to the Virtual Controller or something else needed to connect from another IP range ?

Thanks everyone
Top
jmmcdias
Member
Posts: 11
Joined: 08 May 2009 06:56
Location: Lisbon, Portugal

Re: IAP 105 - Issue to remote access Virtual Controller

Post by jmmcdias »

What is the firmware version???
ACSE R10.0
Top
jmmcdias
Member
Posts: 11
Joined: 08 May 2009 06:56
Location: Lisbon, Portugal

Re: IAP 105 - Issue to remote access Virtual Controller

Post by jmmcdias »

You can config de gateway in system, but You one router? or you can enable local Routing.
You do not have the required permissions to view the files attached to this post.
ACSE R10.0
Top
Post Reply

Return to “OmniAccess Wireless Access Points”