How to check IP SET configuration setting remotely

[gaurav.aggarwal]

HI All,

Greetings!!!

Please help me to know any command or procedure to check the IP Set configuration setting remotely.

I want to check the IP configuration of IT set like:
TFTP1:?
TFTP2:?
STATIC or DYNAMIC: ?

Thanks for your prompt response.

Regards
Gaurav

[murraya]

you can telnet to the phone to check the settings. use the ippstat command to open telnet access to the device.

[gaurav.aggarwal]

Thanks Murray...

This is what I am looking for.

Thanks for your quick reply.. Have a nice weekend!!!

[gaurav.aggarwal]

HI

I am getting below result via telnet IP@ telephone/ config command.
What is the difference between Current and Flash and how can I change FLASH configuration??

Thanks i n advance
For one extension current and Flash values are
config CURRENT
dhcp mode : dynamic
ip addr : 10.233.97.59
subnet mask: 255.255.255.0
router addr: 10.233.97.2
tftp addr 0: 194.4.112.125
tftp addr 1: 255.255.255.255
tftp_backup: 10.233.97.7
tftp port : 69
main cpu 0 : 194.4.112.125
main cpu 1 : 255.255.255.255
main port : 69
VLAN : 100 (0x64)
use VLAN : yes
strict VLAN: yes
boot mode : full
port lan : 100/full
port pc : no link
init mode : 0x0 (none)
phy addr 1 : 194.4.112.126
phy addr 2 : 194.4.112.124
cust (val) : <invalid>
cust (req) :
L10N (val) : <invalid>
L10N (req) :

Regards
Gaurav

[cavagnaro]

Current is what is on memory right now. Flash is what is stored on the set flash mem so when you reboot flash config is loaded into memory (current )

[gaurav.aggarwal]

Thanks Cavagnaro for your quick reply. But could you please tell me who can I reset the Flash memory.

Shall I reset the extension or del/create or any other command or procedure to do do??

Thanks
Gaurav

[cavagnaro]

Why would you wanna do that? Just reprogram the set on the PBX.

[gaurav.aggarwal]

Okay .. Thanks a ton for your help!!!

Regards
Gaurav