mismatch host address when run "lanpbxbuild"

[sinyo]

Hi all,

I am facing problem when configure lanpbxbuild.
After adding CS lines, i try to "apply changes", but OXE give me an error message:
"Mismatch host address 192.168.45.50"
Then the configuration will not saved. (lanpbxbuild always empty)

My configuration is:
- OXE rel 9.1
- CS IP address : 192.168.45.50
- Role IP address : 192.168.45.51

If i put my CS IP address (192.168.45.50) on the TFTP required. It will give me error "Mismatch host address 192.168.45.50".
If i put my Role IP address (192.168.45.51) on the TFTP required. It will give me error "Mismatch host address 192.168.45.51".

Please help me on this problem.
Thank you very much.

[murraya]

hi, have you tried "lanpbxbuild -auto" ?

[sinyo]

Hi Murray,

Thank you for your response.
I have tried "lanpbxbuild -auto", it still gave me same error message.
Is there any other way to solve this?

Thanks.

[murraya]

ok, try to run "netadmin -m" and check cpu address, role address, netmask and default router.
if all looks okay then run "netadmin" and set up from scratch.
is this a live system or are you just building new?