sip incomming from public operator

[airwolf]

Hi

I am having dificulty with inbound sip calls.
I have created my sip external GW and outbound calls work fine, when I dial my SIP number the call is presented to the OXE(seen in traced &) but it does not route anywhere. does anyone have any docs on getting inbound calls from public operator or example of management
My trunk group is isdn all countries and t2 spec is SIP

any help aprpeciated

Chris

[tincho.rn]

Hi. It is like any T2 TG. Check in traces the DNIS coming from public operator, and use traslators. Regards.

[dryhouse]

Hi,

you must declare all ext GW (public operator) in numeric mode (IP addr) and its domain(@domain.xxx). You must declare an anonymous call unidentified.

Regards.

[airwolf]

Thanks for this, my ext GW is set with my public operator IP , not sure about domain(@domain.xxx). what do you mean anonymous call unidentified

[dryhouse]

Calls inbound without identification (sip:anonymous@anonymous.invalid).

Regards.

[letacla.alcatel]

did u check the ports on the router, where ur Public SIP trunk connected..?

I face the same problem, due to the router configuration..

[swinstation]

hi
I faced your problem recently did you solve your problem?
actually I created external gateway and in its remote sip domain I define anonymous@anonymous.invalid but after creatation my I could not call to my extension.please share your experience.

[swinstation]

no idea?

[swinstation]

I found solution.

[cavagnaro]

Will you be so kind to share?