Problem with new 6400

[davidgt]

Hello,

i've got the following problem with 4 6400 Omniswitch. When i boot them, i can't don anything via the console port, it is blocked at the step NIs are ready. I can't do anything on them and during the boot there is the following message: "ERROR : Failed to pre-parse configuration file </flash/working/boot.cfg>". I have tried to hit a key at the beginning of the boot to have access but with the same result. Does anybody already encountered this and solved it?

Best regards.

[davidgt]

I have found what was the problem, it was due to the flow control in hyperterminal that was to material by default.

[cedric1]

hello

Message you get is normal because you have no boot.cfg file on your system (config file)

configle is created by the switch when you enter "write memory"

Did you use console cable from the box ? Read the doc to have correct setings for serial settings on your pc.

If you have same pb on 4 switch, I thinks pb come from your pc settings.

Console Port

baud rate 9600
parity none
data bits (word size) 8
stop bits 1
X-ON/X-OFF enabled

Cedric