6400 Boot Problem

[Mehdi]

Hi,
I tryed to update the boot with internet interface.
I copied the ku-boot.bin and the gminiboot.uboot files in flash directory.
When i start the "switch" i'm here :

U-Boot (6.3.3.276.R01) (for OS6400, OS6850, and OS6855 platforms) (Aug 5 2008 -
15:13:11)

MPC8247 Reset Status: External Soft, External Hard

MPC8247 Clock Configuration
- Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq 25-75 , Core Freq 100-300
- dfbrg 0, corecnf 0x1a, busdf 3, cpmdf 1, plldf 0, pllmf 3
- vco_out 400000000, scc_clk 100000000, brg_clk 100000000
- cpu_clk 400000000, cpm_clk 200000000, bus_clk 100000000
- pci_clk 66666666

CPU: MPC8247 (HiP7 Rev 14, Mask 1.0 1K50M) at 400 MHz
Board: Alcatel OS6400 (Garuda)
I2C: ready
DRAM: 256 MB
FLASH: 128 MB
No environment variables found, using defaults

In: serial
Out: serial
Err: serial

No ethernet found.
Hit any key to stop autoboot: 0
## Booting image at ff900000 ...
Image Name: miniboot-6.3.3.276.R01
Image Type: PowerPC VxWorks Kernel Image (gzip compressed)
Data Size: 864851 Bytes = 844.6 kB
Load Address: 00005000
Entry Point: 00005000
Verifying Checksum ... Bad Data CRC
=>


PRI, PWR, BPS led are down
Ok led flash orange....

anyone can help me please?

[benny]

What did you try?

There are no upgrades for the Miniboot etc for OS6400 yet.

You managed to mess up your Miniboot ... wow.

Open a SR with Alcatel-Lucent, I don't think that you have any other choice.

-benny

[Mehdi]

Ok...

Thank you Benny.