busy tone detection in OXO

[marcelo.abreu]

when I need to put in NDDI trunk - Busy Tone Detection in enabled mode, happens problem in the connections.
at the first, the call is started normally, after short minutes this call is disconected. this only happens if I enable "busy tone detection" in NDDI trunk from OXO.
I tested and the same problem happens in all OXO releases (2.x, 3.x, 4.x, 5.x and 6.x).
Brazilian sistems.

I don´t know, what I can do to solve this problem. there is any Noteworthy???

can anybody help me?

[et]

May be you need to increase "MinBusySeq" in Debug Labels. We set to 07 in our country. This is Minimum number of Busy sequencies for disconnect. Warm reset needed.

[tot3nkopf]

You must set parrameters in accordance to your country/or telco defaults. Search this forum for a simmilar post of mine.

Regards.

[marcelo.abreu]

OK - success
I changed "MinBusySeq" from 3 to 7 and after many tests, do not happens problems.
Thanks very much