CS-2 software loading

[mtcl]

Following a HD crash, I try to load a 10.1.1 release in a CS-2 board on a new HD, using OpmiPCX installer on a windows XP PC
I get nothing on OpmiPCX installer, so I checked the BIOS and there is no option for boot from Ethernet (the option "IBA GE Slot 0200 v126" is missing from BIOS).

Any idea ?

Thanks

[mustafa.ahmad]

What are you getting on the console port of CS2 ?

[mtcl]

Hi Mustafa

This is the console output:
Version 1.23.1109. Copyright (C) 2007 American Megatrends, Inc.
ALCATEL CS-2 BIOS VERSION 0ABPT110
Press ^B to enter setup.
Press ^I to boot EFI SHELL


and the Boot options are:
"Disabled in BBS Order"
"SATA: WDC WD5000LPCX-22VHAT1"
"Disabled"

However, as I notice on the PC, the LAN port of the CPU is active

[mustafa.ahmad]

This is the console output:
Version 1.23.1109. Copyright (C) 2007 American Megatrends, Inc.
ALCATEL CS-2 BIOS VERSION 0ABPT110
Press ^B to enter setup.
Press ^I to boot EFI SHELL

No need to press anything, just allow it to proceed, it will come to the stage where it will try to boot from the network .
Then the PCX installer will come into play and load the OS and Call handling software.

[mtcl]

That was my first reaction and I left the system in this state for 15 min. However, the same information (Press ^B...) keeps repeating

[vad]

PC Installer version?
Show all CS output.
Disable all network adapter on PC (except Ethernet).

[mtcl]

The version is 4.1 and there is no other adapter on PC. This is PC, used only for Alcatel software downloading. I tested on another card and it works fine