Page 1 of 1

PRI line configuration

Posted: 30 Jun 2009 05:47
by samehit
Hi all
I will used PRI Trunk with 30 chanal, my DID is 8 digit
How can i assing specail number of reange 29620000 - 29620999 to users and incomming call routing dirctly to them (such as 29620001 for set 190) by DDI ?

Please can anyone help me, and give me steps how to configure DID ?

thanks & Beast Regard

Re: PRI line configuration

Posted: 30 Jun 2009 15:57
by johank_DUP
This is just the basics of it, for a more detailed explanation you will have to check the manual.

On the Trunk Group set:

DID transcoding : True

Then go to:

Translator > External Numbering Plan > DID number translator > DID number translator rules

First External Number : (Enter the first number that you want to translate, eg. 29620000)
First Internal Number : (Enter the number (or extension) you want to translate it too, eg. 190)
Range Size :(For how many numbers will this translation be done? Usually 300)

You must check with the Telecom provider how many digits they send you. Its not necessarily the full number. In SA we receive only 4 digits from them.

Re: PRI line configuration

Posted: 01 Jul 2009 01:23
by sera544
Hi johank..

He posted in OXO topic not a OXE configuration....

Re: PRI line configuration

Posted: 01 Jul 2009 08:14
by elkiwi
You have to configure it in public numbering plan (and restricted if you want) like extension or hunting group (in case that you want to redirect the call to a hunting group).

In your example:

start end base
extension 29620001 29620001 190

regards

Re: PRI line configuration

Posted: 01 Jul 2009 08:16
by elkiwi
sorry lang mistake, i ment subscriber not extension.

hope it helps

Re: PRI line configuration

Posted: 01 Jul 2009 08:56
by samehit
thanks sir

but I need configuration in OMC
that is because i work in OXO System

Please help me

thanks & Beast Regard

Re: PRI line configuration

Posted: 01 Jul 2009 10:23
by elkiwi
elkiwi wrote:You have to configure it in public numbering plan (and restricted if you want) like extension or hunting group (in case that you want to redirect the call to a hunting group).

In your example:

start end base
extension 29620001 29620001 190

regards
samehit, this is OXO Config.