Page 1 of 1
AP61 - Factory Default
Posted: 29 Apr 2009 18:24
by tincho.rn
Hi. Is it possible to reset the AP to factory default with the Ethernet-to-Serial cable?. Thanks in advance. Regards
Re: AP61 - Factory Default
Posted: 15 May 2009 04:46
by annabelle
Yes it's possible
First check that soe (serial over ethernet) is activated in your controller.
When your AP is connected to the APC throught your cable, you will see the autoboot sequence. Follow this sequence :
apboot > purge
apboot > save
Erasing ...
Programming ...
Verifying ...
apboot > boot
Re: AP61 - Factory Default
Posted: 17 May 2009 19:29
by tincho.rn
Thanks for your help. Regards.
Re: AP61 - Factory Default
Posted: 06 Nov 2009 13:35
by nperalta
Hi , I have 70 ap (ap60,61) provisioned and working. but i have a Ap where the controller no see the ap o the ap fails now i need factory default the AP to verify the ap is good.
if I still the steps. lost the others ap configured ??
apboot> purge
apboot> save
Erasing....
Programming...
Verifying....
apboot>boot
help (I'm sorry the wording of chile)
bye