Alcatel Unleashed

I've been trying to configure NTP on our 6850 switches. The master ntp server has been created using a router and it's working. Everytime i tried to synchronize with the Ntp master, the system time is alwasy off 30 minutes or 1 hour. I can do it manually to correct the time, but it's not the way NtP works.

My cisco 6500 is acting as ntp master and our 6850s tons of them are configured clients.

ntp master ip-address
system timezone PST

Thanks,
Circuitid

Ntp master ip-address
system timezone PST

I would like to configure the clock UTC - 8 .. but it doesn't allow me..


Thanks,
CircuitID

Try to use the following command:
-> system timezone -08:00

-benny

Hi,

I'm havinf the same problem with the NTP settings on a the 68XX,64xx and 97xx
I have a windows 2003 server with Omnivista 2500.
On the server i have enabled SNTP.
Also in the network i have more the 70 62XX switches they all time snyc OK but when i try this with the 64XX,68XX and 9700 i have a -2 hours on teh switch time.

How can i solve this issue ????

kind regards
Paul van Drongelen

hello

Did you enter command

system daylight savings time enable

and

system timezone "your time zone"

I have ntp and no issue with these settings

Regards

Cedric