Page 1 of 2
regarding vlan on oxe
Posted: 31 Oct 2005 12:17
by kenzo_DUP
would like to segment our voice and data into different segment by means of VLAN. As such, please take this into consideration in preparing a IP phone network design. Please provide us the necessary information (e.g. what is the IP address range you required, number of VLAN segment, etc) required in order for our vendor to prepare the switch. The switch which we will be using is the Cisco Catalyst 4506 with 2x 48-ports (10/100/1000) PoE modules and 1x 48 ports (10/100/1000) normal Ethernet module.
anyone can help on this thanks
Posted: 31 Oct 2005 21:21
by frank
Your vendor should provide you the informations needed..
Posted: 31 Oct 2005 21:25
by kenzo_DUP
on my site what i need to configure for VLAN
Posted: 31 Oct 2005 21:29
by frank
Your cisco catalyst is a serie 4500.
Serie 4500 is vlan capable (IEEE 802.1Q).
You just need a CCNA to configure it
Posted: 31 Oct 2005 21:33
by kenzo_DUP
ok thank.
On the mgr oxe side do i need to configure anything thanks
Posted: 31 Oct 2005 21:36
by frank
You will need to configure the VLan on the IP phones.......
Posted: 31 Oct 2005 21:38
by kenzo_DUP
ok will do how about the DHCP side at mgr........
it so simple to set.....
Posted: 31 Oct 2005 21:41
by frank
If you go DHCP, you just have to manage the DHCP vlan, that's all
Posted: 31 Oct 2005 21:44
by kenzo_DUP
mean to say the vendor need to give me the range IP Address......public
Posted: 31 Oct 2005 22:00
by frank
No, no public address !
The IP phone should be in a private network.
Choose something like 192.168.x.x