Alcatel Unleashed

Hi all!
I want to connect two E1 trunks to OXE PRA2 board. But I can not find any documentation in which explains pinouts for TY2 cable pairs: TxRINGa (TxTIPa), RxRINGa (RxTIPa), TxRINGb (TxTIPb), RxRINGa (RxTIPa). Help please. Thanks!

See the Alcatel System Doc in the right top of your screen.

Regards.

Yes, documentation contain pinouts for boards PRA2 and cable TY296PTSDIN indicated there T2TXb(1), T2TXa(1), T2RXb(2) and T2RX(2) but I don`t understand how to interpret these abbreviation. What in this abbreviation is the number of a trunk and pair of wires? I think T2TXa(1) is the first trunk transmit pin on the first pair (red wire). But in this case it is not clear tip or ring? As I understand it, for the two streams should be at least 8 wires in the documentation declared only 4. If you can, please explain? Thank you

The PRA board only accepts 1 E1 cct the pin outs are transmit + and - and receive + and -

The NPRAE however can have two E1's in which case I think that the first 2 quads on the cable are used (that would have to be checked though)

K.

Sorry, i made mistake, i have NPRAE board. I found шт system documentation pinout for the two trunk, try to check in the near future. Thank you!