alcatel E1 link

[kenzo_DUP]

Image of the E1 card, 1 of this card will be in the router CS 2621 XM from Cisco.
When choosing to connect the Router to the PBX with a E1 ISDN interface,
the cable between the router and the PBX depends on the PBX brand. (Alcatel, Siemens,
Nortel, Panasonic) and will need to be custom made.
On the router side, the card requires the use of a RJ-48C interface connector.
Image of the ISDN E1-card
The information on receive / transmit signals is indicated below on the router side:
On the PBX side, the interface depends on the PBX type
Please consult the PBX vendor to get the interconnection cable,
The pin layout for the PBX depends on the connection to the PBX’s ISDN E1 card.
Some examples are included:
or
Make sure that the PBX vendor is aware of the send / receive signals.