Alcatel Unleashed

when I need to put in NDDI trunk - Busy Tone Detection in enabled mode, happens problem in the connections.
at the first, the call is started normally, after short minutes this call is disconected. this only happens if I enable "busy tone detection" in NDDI trunk from OXO.
I tested and the same problem happens in all OXO releases (2.x, 3.x, 4.x, 5.x and 6.x).
Brazilian sistems.

I don´t know, what I can do to solve this problem. there is any Noteworthy???

can anybody help me?

May be you need to increase "MinBusySeq" in Debug Labels. We set to 07 in our country. This is Minimum number of Busy sequencies for disconnect. Warm reset needed.

You must set parrameters in accordance to your country/or telco defaults. Search this forum for a simmilar post of mine.

Regards.

OK - success
I changed "MinBusySeq" from 3 to 7 and after many tests, do not happens problems.
Thanks very much