Alcatel Unleashed

Hello,

I have 10+ OS6450 (10Port - 48Port) Switch.
Since a few days I get no LLDP Information.

There are three HP 2920 there I get the Information.
For example: 0815-SW-01
Show lldp remote-system
Port 1/52 gave mit the information HP-2920-xxxx
Port 1/51: no Information - on this Port is a OS6450-P48

Enable LLDP with the command.
Configure
LLDP RUN

Didńt work. - Wrong Command

Thanks for Help Regards

you can check the lldp config at the ports (rx+tx) with show lldp config.
Show lldp 1/51 statistics - maybe some errors?
If you have any changes and can't find the reason: reload of the switch
BR Silvio

Hy thanks,

I have already reload the switch. nothing have changed.
will try it.

How can i enable LLDP an Ports.
Command
Config
Lldp run

—> wrong command

regards

per default it is enabled. You check with "show lldp config" (Rx + Tx)
Enable it at all ports with "lldp chassis lldpdu tx-and-rx"
BR Silvio