Alcatel Unleashed

hello.
First of all, thanks a lot for your help.

model : OS6360-PH24
OS version : 8.8.56.R02 GA, 8.9.73.R01 GA

"aaa switch-access mode enhanced"
After entering this command, an equipment reload error occurred.
forced reboot, it kept rebooting again and again.

"aaa switch-access mode default"
After changing this config, the reload error still occurs.
but forced reboot, it works fine.

I'd like to know why this is happening.
The following is the error message that occurs when entering the reload command.

reload error message
-> reload from working no rollback-timeout
Confirm Activate (Y/N) : y
This operation will verify and copy images before reloading.
It may take several minutes to complete....

Tue Sep 13 07:11:58 : ChassisSupervisor vcReloadMgr INFO message:
+++ vcReloadMgrReloadVC: starting reload sequence for image working

Tue Sep 13 07:12:04 : flashManager Main INFO message:
+++ Verifying image directory working on CMM flash

Tue Sep 13 07:12:25 : flashManager Main INFO message:
+++ Verifying image Integrity on directory working on CMM flash
ERROR: Image verification failure on master chassis

Tue Sep 13 07:12:25 : ChassisSupervisor reloadMgr ERR message:
+++ reloadMgrStateMachine: Reload Primary or Image: Verify of reload image failed - terminating request

Tue Sep 13 07:12:25 : ChassisSupervisor vcReloadMgr ERR message:
+++ vcReloadMgrRcvCallback: verify failed for chassis 1 reason Image verification failure on master chassis


Tue Sep 13 07:12:25 : ChassisSupervisor vcReloadMgr ALRT message:
+++ Reload failed due to image copy or validation failure

Tue Sep 13 07:12:25 : ChassisSupervisor vcReloadMgr ERR message:
+++ Chassis failing to respond to VC reload: 1,

It says "Image verification failure on master chassis", so replace the installed firmware.

Like Gleylancer is writing - the validation of the installed image has failed.
I have seen this sometimes after copying the img-files via usb. So load the software via sftp/ftp ....
BR Silvio