7360 ISAM NT redundancy problems
Posted: 23 Jun 2021 05:01
Hi Im trying to setup two FANT-F cards in a 7360 ISAM in active-active redudnacy but currently they arent even working in active-standby mode.
They both have identical software on them and are detected. I can boot the system off either the NT-A or NT-B by removing one of the cards before power up but once its running it wont switch over:
Any ideas what the issue is?
They both have identical software on them and are detected. I can boot the system off either the NT-A or NT-B by removing one of the cards before power up but once its running it wont switch over:
Code: Select all
admin equipment protection-group 1 switchover
Error : REDCY MGT error 10 : The standby NT is not in hot-standbyCode: Select all
show equipment protection-element nt-a
================================================================================
protection-element table
================================================================================
slot-id |standby-status |group-id|redcy-ctrl-status|stdby-chg-reas
-----------+-----------------+--------+-----------------+-----------------------
nt-a providing-service 1 normal none
--------------------------------------------------------------------------------
protection-element count : 1
================================================================================
show equipment protection-element nt-b
================================================================================
protection-element table
================================================================================
slot-id |standby-status |group-id|redcy-ctrl-status|stdby-chg-reas
-----------+-----------------+--------+-----------------+-----------------------
nt-b idle 1 normal peer-lckd
--------------------------------------------------------------------------------
protection-element count : 1
================================================================================
show equipment protection-element
================================================================================
protection-element table
================================================================================
slot-id |standby-status |group-id|redcy-ctrl-status|stdby-chg-reas
-----------+-----------------+--------+-----------------+-----------------------
nt-a providing-service 1 normal none
nt-b idle 1 normal peer-lckd
show equipment slot nt-b
================================================================================
slot table
================================================================================
slot |actual-type|enabled|error-status |availability |restrt-cnt
-----------+-----------+-------+----------------------+-------------+-----------
nt-b fant-f no no-error available 0
--------------------------------------------------------------------------------
slot count : 1
================================================================================
show equipment slot nt-a
================================================================================
slot table
================================================================================
slot |actual-type|enabled|error-status |availability |restrt-cnt
-----------+-----------+-------+----------------------+-------------+-----------
nt-a fant-f yes no-error available 0
--------------------------------------------------------------------------------
slot count : 1
================================================================================