Page 1 of 1

7210 SAS-D Management Interface Configuration Question

Posted: 03 Dec 2020 00:59
by zveroboy152
Hey All,

Im having a really hard time configuring a management interface on a few of my 7210 SAS-D (and Dx).

I have all my ports Op Up, and Admin Up'd, and have it set in the bof:
===============================================================================
primary-image cf1:\both.tim
primary-config cf1:\config.cfg
#uplinkA Port Settings:
uplinkA-port 1/1/10
uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 1000
uplinkA-address 192.168.1.171/24
uplinkA-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
===============================================================================

But, I cannot ping the MGMT interface from the same LAN. I've been reading over the Docs, but I seem to be missing something.. Any ideas? :-)

Re: 7210 SAS-D Management Interface Configuration Question

Posted: 07 Jan 2021 11:10
by paramount
Hi,

Did you get this sorted? Had the box been rebooted since you modified the bof for management etc?

Paramount