6860 Gre tunnel

Post Reply
k1102503
Member
Posts: 4
Joined: 13 Mar 2020 02:39

6860 Gre tunnel

Post by k1102503 »

Hi ,

I recently tried to connect gre tunnel between cisco and AOswitch.
I make the gre tunnel like the guide book did ,but I can't found the command to set the tunnel key and mtu.
-> ip interface "gre" tunnel source 23.23.23.1 destination 155.2.2.2 protocol gre
-> ip interface "gre" address 24.24.24.1 mask 255.255.255.0

Here is the cisco's command
--------------------------------------------------------------------------------
interface Tunnel1020123577
ip address 10.201.200.86 255.255.255.252
ip mtu 1532
ip ospf network broadcast
ip ospf cost 10
tunnel source 10.201.200.78
tunnel destination 10.201.200.77
tunnel key 1020145699
--------------------------------------------------------------------------------
How to set the tunnel key and mtu on AOswitch ?

Best wishes,
k1102503

silvio
Alcatel Unleashed Certified Guru
Alcatel Unleashed Certified Guru
Posts: 1431
Joined: 01 Jul 2008 10:51
Location: Germany

Re: 6860 Gre tunnel

Post by silvio »

You can change the MTU in the vlan
> vlan 180 mtu-ip 1532

But I have never seen the possibility to set the optional key. You can check with wireshark, which key is used (or empty) and set the same at cisco.
Or open a ticket at Alcatel.
regards
Silvio

Post Reply

Return to “OmniSwitch 6860 / 6860E”