Page 1 of 1
configuring ntp services
Posted: 20 Mar 2018 09:21
by madidi123456789malo
Hi Everyone,
I am configuring NTP in my 6850 Alcatel switch ,Switch is not synchronised with NTP server
NTP configuration as below , anyone suggest how to resolve this issue .
Capture2.PNG
Capture.PNG
Re: configuring ntp services
Posted: 21 Mar 2018 03:31
by devnull
try to wait some time, but if you want to get time from a server that is NOT synced against some Master clock (from your output visible as it is stratum 16) it will not work.
From Manual:
"Note
The NTP protocol discards the NTP servers that are unsynchronized.
To disable an NTP client from invoking tests for NTP server synchronization, enter the
ntp server unsynchronized command, as shown:
-> ntp server unsynchronized
Disabling peer synchronization tests allows the NTP client to synchronize with either an NTP peer that is not synchronized with an atomic clock or a network of NTP servers that will finally synchronize with an atomic clock."
So
ntp server unsynchronized
should help