Opentouch LACP to Cisco Switch

Post Reply
afasquel
Member
Posts: 1
Joined: 13 Oct 2017 09:06

Opentouch LACP to Cisco Switch

Post by afasquel » 13 Oct 2017 10:00

Hi,

I have an Opentouch that needs dual attachement to the cisco switch through a port channel (LACP).
Normally under suse we can do this under the Bond Interface.

OT needs a bridge interface during the install and apparently it bridges the eth and the vmnet interfaces.

Is there any ways to tell the open touch to use the bond interface instead of the bridge ?

I see that the bridge can be configured as a slave interface of the bond. Has anyone tried this configuration ?

Share your experience please

Alex

Post Reply

Return to “MAIN”