Page 1 of 1
Power Fail Cut Through on PRA-T2 card
Posted: 17 Sep 2007 02:28
by roly@rbmit.com.au
Hi All
is it possible to do have a power fail cut through on a PRA-T2 card ? If so, what do I need to do set it up ? If not through the OXO itself, what would I need to provide the facility to my system ?
Thanks for any advice.
Re: Power Fail Cut Through on PRA-T2 card
Posted: 18 Sep 2007 00:17
by Jigger
What do you mean by cut through?
If you mean you have had a power fail and now the PRA-T2 is not working, you will most likley need to replace it.
Re: Power Fail Cut Through on PRA-T2 card
Posted: 18 Sep 2007 00:55
by roly@rbmit.com.au
[quote="Jigger"]What do you mean by cut through?
If you mean you have had a power fail and now the PRA-T2 is not working, you will most likley need to replace it.[/quote]
Same as the PFCT (Power Fail Cut Through) on the AMIX cards. In the event of a power failure all inbound calls get routed to a particular port so you still have some functionality.
Re: Power Fail Cut Through on PRA-T2 card
Posted: 18 Sep 2007 12:57
by tot3nkopf
Not possible through Alcatel PBX.
Regards.
Re: Power Fail Cut Through on PRA-T2 card
Posted: 18 Sep 2007 18:21
by roly@rbmit.com.au
tot3nkopf wrote:Not possible through Alcatel PBX.
Regards.
Thanks for the confirmation - I couldn't see any mention of it in the Expert Documentation.
Is there an external solution that I might be able to look at ?
Re: Power Fail Cut Through on PRA-T2 card
Posted: 28 Sep 2007 03:38
by Jigger
roly@rbmit.com.au wrote:Jigger wrote:What do you mean by cut through?
If you mean you have had a power fail and now the PRA-T2 is not working, you will most likley need to replace it.
Same as the PFCT (Power Fail Cut Through) on the AMIX cards. In the event of a power failure all inbound calls get routed to a particular port so you still have some functionality.
Sorry bud, didnt read your post very well at all... Just so used to giving those kinds of answers...
Again, my bad! Ciao