Page 1 of 1
How to upgrade OXE R6.2 (CPU6) to R11.2(CPU7-2)
Posted: 16 Mar 2017 07:32
by rizwanqureshi
Hi,
I need procedure for OXE software Release up-gradation from R6.2 to R11.2. The existing hardware is CPU6 and this CPU6 has to be replaced with CPU7-2 during the up-gradation. A new GPA2 board will also be added in OXE as per OPS file received to me.
Regards
Rizwan
Re: How to upgrade OXE R6.2 (CPU6) to R11.2(CPU7-2)
Posted: 16 Mar 2017 08:55
by vad
Read TC (f.e. TC2122)
Do you have - system SW (R11.2), access to BPWS, some experience with OXE SW installation?
Re: How to upgrade OXE R6.2 (CPU6) to R11.2(CPU7-2)
Posted: 17 Mar 2017 01:40
by rizwanqureshi
Well, I have downloaded OXE R11.2.2 from BPWS and I have experienced of OXE SW installation.
Please guide me about procedure for OXE SW Release migration, step by step.
Regards
Re: How to upgrade OXE R6.2 (CPU6) to R11.2(CPU7-2)
Posted: 17 Mar 2017 01:44
by rizwanqureshi
Further to add that I have new OPS (R11.2) for the migration, as well
Re: How to upgrade OXE R6.2 (CPU6) to R11.2(CPU7-2)
Posted: 17 Mar 2017 02:25
by vad
Read f.e. TC 2122 (or another TC about R11.2 installation).
But in any case main step:
1 - Rebuilding the database before saving - cdmao, fichges force_recover_dico (p. 9.4 from TC2122)
2 - Save database
3 - Install R11.2 to CPU7, manage IP addresses (netadmin)
4 - Restore database from R6.2
5 - Install new OPS (for R11.2).
6 - Check installation, make correction if needed (f.e. if VG was on CPU6 - manage VG on GPA2).