[Resolution]oxe R10.1.1 29b install on HP DL320 gen8

Are you having any trouble while you are configuring a 4400 on site ? Share it with us, maybe someone will have the solution !
Post Reply
thkim81
Member
Posts: 311
Joined: 15 Jun 2009 22:57
Location: korea

[Resolution]oxe R10.1.1 29b install on HP DL320 gen8

Post by thkim81 » 25 Nov 2014 19:35

hi~

OXE installing on HP DL320 gen8 . but iLO port using with occur below error.



* loadDeviceDriver(SCSI): 0x1
* failed to open /proc/scsi/scsi: No such file or directory

TC1800 checking sata configuration and com1 port setting checked and server status normal.

why oxe install fail from cause ? server problem ? oxe installation file ?

ps : oxe installation again new file in BPWS. but fail.

thkim81
Member
Posts: 311
Joined: 15 Jun 2009 22:57
Location: korea

Re: [Resolution]oxe R10.1.1 29b install on HP DL320 gen8

Post by thkim81 » 23 Dec 2014 21:27

this issue resolved

cause HP server mainboard H/W fault.

HP Engineer enter inside then change mainboard.

clear all!!!!

gyiasoumas
Member
Posts: 3
Joined: 16 Feb 2015 07:50

Re: [Resolution]oxe R10.1.1 29b install on HP DL320 gen8

Post by gyiasoumas » 16 Feb 2015 08:02

Hello thkim81,

I face the same problem as you and I want to send the server back to the supplier. My problem is that we don't have direct HP, but HP reseller in my country so I might have a problem to prove to them that my problem is their hardware's problem.
How did you specify your problem to HP in order for them to analyze the incident and give you a solution?
Thanks in advance

unitz
Member
Posts: 6
Joined: 14 Dec 2010 22:40

Re: [Resolution]oxe R10.1.1 29b install on HP DL320 gen8

Post by unitz » 07 Apr 2016 16:13

Hi gyiasoumas and thkim81,

We are having the same error. Could you please tell us how it was fixed? TC 1800 and 1897 have not been much of help for this issue.

pci probe found 0 SCSI devices
* in device handler
* loadDeviceDriver(SCSI): 0x1
* failed to open /proc/scsi/scsi: No such file or directory

Thanks so much,
unitz.

unitz
Member
Posts: 6
Joined: 14 Dec 2010 22:40

Re: [Resolution]oxe R10.1.1 29b install on HP DL320 gen8

Post by unitz » 14 Apr 2016 14:08

Hi, The issue has been resolved. There is nothing wrong with the hard drive or sata controller. The virtual serial port has to be set to COM1. All this while we had it set to COM2. Also follow the TC 1897 and 1800. The following knowledge base article is also helpful:

http://alcatel-lucent-enterprise.force. ... l&q=tc1897

Holger
Member
Posts: 1
Joined: 26 Jul 2017 02:08

Re: [Resolution]oxe R10.1.1 29b install on HP DL320 gen8

Post by Holger » 19 Sep 2017 05:26

Start ilO Session with command vsp

Post Reply

Return to “ON SITE TROUBLES”