Problem with new rel11 feature "two 40keys AOM"
Posted: 15 Oct 2014 09:41
Hi,
Since Oxe rel 11.0 there is a new feature to add two 40 kes AOM panel to 40x8 phones.
This is managing : System > Others System Param. > Spec. Customer Features Parameters > x89 40 keys AOMV
The issue is the OXE allow programing both AOM panels on user management, but never recognize the second AOM (only works the directly connected to the phone).
I 'm using a 4038 phone and have already interchanged the position of AOM panel and the failure remains on the position (not the depends of hardware)
I have changed the phone too,reboot the OXE, an the phone and the failure remains the same.
I am attaching the configuration and the termstat results.
I will appreciate feedback if someone was tested this function.
Thanks in advance,
M
Since Oxe rel 11.0 there is a new feature to add two 40 kes AOM panel to 40x8 phones.
This is managing : System > Others System Param. > Spec. Customer Features Parameters > x89 40 keys AOMV
The issue is the OXE allow programing both AOM panels on user management, but never recognize the second AOM (only works the directly connected to the phone).
I 'm using a 4038 phone and have already interchanged the position of AOM panel and the failure remains on the position (not the depends of hardware)
I have changed the phone too,reboot the OXE, an the phone and the failure remains the same.
I am attaching the configuration and the termstat results.
I will appreciate feedback if someone was tested this function.
Thanks in advance,
M