LSP primary path oper down with FRR enabled
Posted: 09 Sep 2014 11:02
Hi everyone,
Each time i enable FRR (whatever type) on the LSP, the primary path won`t get up. Even if I swap the paths- make the one that was secondary just befor a primary path, it`s always the primary path that stays down, while secondary is up.
Any ideas what could be the reason?
Each time i enable FRR (whatever type) on the LSP, the primary path won`t get up. Even if I swap the paths- make the one that was secondary just befor a primary path, it`s always the primary path that stays down, while secondary is up.
Any ideas what could be the reason?