Alcatel Unleashed

Hi,

I have to install an NPRAE2 board but only have a TY1 64PTSDIN cable (instead of the designated TY296PTSDIN).
I investigated and there aren't many differences in the cables pinouts.
Has anyone experienced using the TY1 instead of TY2? What is the difference between them?

Thanks in advance.
M

Hola,
Tengo que instalar una placa NPRAE2 y solo tengo disponible un cable TY1 64PTSDIN ( en lugar del cable designado TY296PTSDIN).
Estuve mirando y a nivel del pinout del cable no habría mayores diferencias.
Alguien tiene experiencia usando este TY1 en luger del TY2? Cual es la diferencia entre ambos?

Desde ya muchas gracias.
M

take a look in the technical docs.

in short words...
ty2 cable is for nprae
ty1 cable is for equipment like ua / analog or bra (category 3)

regards...

tgn wrote:take a look in the technical docs.

in short words...
ty2 cable is for nprae
ty1 cable is for equipment like ua / analog or bra (category 3)

regards...

Hi Tgn,
Thanks for your response.
And yes, I have read the docs and I know each board have a specif cable , I don´t see any difference on pin-out reference thats the reason why I'm asking.
The idea is use this TY1 as workaround while the TY2 is ordered.

Thanks.
M

If you know the right pins its possibile .....sometime we cut the cable and use only the connector if a cable already exists from provider side

hi
have a nice day
please can you give me the distance range cable between two NPRAE_2

Thanks
H

hi
Have a nice day
I instaled npri_2 for the interface with pbx ( haris) as E1 by the modem the my pbx alcatel can send 30 channels send and receive 2 channel only by other PBX I want to know if the problem with me or other Pbx can you give me the result as soon as possible ( I needed urgently )

thanks

H