Configuring CPC on eZ32-2

[tjm0852]

I see that CPC (calling part control) or open loop disconnect is now supported in R10 on eZ32-2 boards http://www.abst.com.tw/abpp/OXE%2010.0/ ... 2010.0.pdf

However I am not finding any documentation on how to configure that. Does anyone know?

Thanks

[tjm0852]

I found this:

"To configure the CPC signal on OmniPCX Enterprise, see: module Z32/eZ32 / Configuration procedure / User Declaration."

But navigating the R10.1 documents I see nothing under z32/eZ32 about configuration procedure.

[cavagnaro]

Seems you need to ask ALU about that document. Open an eSR with them to make them know the missing doc.

[tjm0852]

Seems you need to ask ALU about that document. Open an eSR with them to make them know the missing doc.

Thanks, but I do not have access to the BP website to open an eSR

[tjm0852]

I found the timer, its a new parameter under user when a user is assigned to a eZ32-2 board.

[cavagnaro]

Nice. Thanks for sharing