Alcatel Unleashed

Hi all,

I have an existing policy network group as below.
"policy network group test 192.168.3.1 192.168.3.23"

I want to add another object 192.168.3.2 to it so i use the below statement.
"policy network group test 192.168.253.2"

When i do a "show configuration snapshot" the object 192.168.3.2 doesn't show up under network group test.
But when i do a "show policy network group" i can see that the object 192.168.3.2 is under network group test.

Pls advise the proper command to modify network group. TIA!

in my knowledge the used command is ok. Did you use qos apply?
sometimes its good to delete the group completely and create it new with all entries in one line.
regards
Silvio