Page 1 of 1
Issue setting up GD3 board in Remote Shelf
Posted: 06 Apr 2012 08:55
by jbower
I am trying to setup the Ethernet Param for a GD3 board for remote shelf. When I try to set the IP information i get an error message. I have attached what I tried to program in the attachment.
Ether Param.JPG
Then I get an error message that i also have attached.
error message.JPG
Re: Issue setting up GD3 board in Remote Shelf
Posted: 07 Apr 2012 09:40
by patmul39
you cannot manage the IP paramaters under the Ethernet Parameters of the GD - however you have to manage the MAC address. Then connect to the GD (manually, by serial cable) and manage the following:
Startup mode - Dynamic or Static
IP address
Netmask
Gateway address
TFTP server address - Your OXE main IP address
Callserver address
Crystal number - Manual entry or Dynamic allocation
VLAN menu - if you use VLAN or tagging packets (DSCP)
on your OXE you must already have your TFTP file available (lanpbxbuild)