Instalção
Posted: 12 Jan 2012 18:27
Good afternoon!
I installed a PBX Crystal ACT 28, R2 are two links that do not work, the plates are signaling you read the AIS and 64K, MAM, I've done this with the operator the same information that my panel is forcing CRC4, changed the istraps (x25A and x25B). reread current R9.1 patch 34 has switch plate, with the cabinet with relesse.Instalei gd3 plates pcm-r2 both OmniPCX Office is running fine but when I go back to the crystal does not work? I have already tested the patch exchange cards and connect another link from another carrier on the same boards, same route for several customers and they are usually run from. It can be any configuration of the operator or central? Distance from the center can link with and influence anything? (Now this one with distance + or - 100 meters.
Thanks for your participations
Marcio Fernando Diniz – Técnico 1
Tel: +55 (31) 3330-7013 – Cel: +55 (31) 9734-5107
Fax: +55 (31) 3330-7006 – marcio.diniz@alctel.com.br
www.alctel.com.br
I installed a PBX Crystal ACT 28, R2 are two links that do not work, the plates are signaling you read the AIS and 64K, MAM, I've done this with the operator the same information that my panel is forcing CRC4, changed the istraps (x25A and x25B). reread current R9.1 patch 34 has switch plate, with the cabinet with relesse.Instalei gd3 plates pcm-r2 both OmniPCX Office is running fine but when I go back to the crystal does not work? I have already tested the patch exchange cards and connect another link from another carrier on the same boards, same route for several customers and they are usually run from. It can be any configuration of the operator or central? Distance from the center can link with and influence anything? (Now this one with distance + or - 100 meters.
Thanks for your participations
Marcio Fernando Diniz – Técnico 1
Tel: +55 (31) 3330-7013 – Cel: +55 (31) 9734-5107
Fax: +55 (31) 3330-7006 – marcio.diniz@alctel.com.br
www.alctel.com.br