Alcatel Unleashed

Dear All,

I have critical case with ERP ( 4 Ring ). From this forum and AOS manual i read the example for erp.

I tried config ERP with vlan stacking or vlan standar.

The problem is network looping make my switch drop (RTO).

You can see the topology on the attachment ( split to 2 ring )
Note : on the topology, I used stacking vlan. from the same topology i tried to use vlan standard. With stack vlan or standard vlan I met a same problem (network Loop).

Please your advice how to handle multiple ring and network loop on ERP environment.


Regards / Henrizal Koto

Hi,

Is there anyone experienced with this case ?

Please your help

Regards / Henrizal Koto

hello

You are in limitation of ERP design. So your design doesn't fit in what we can done with ERP.

As you have connectivity between all devices make so a real ring 1 only.

See picture for correction.

So delete ring 2 .
Use only ring 1.
Delete link between SW3 and SW4

All will work fine.

Cedric

If I am correct, "multiring" support will be available later on this year.

In the network configuration manual is clearly stated:

• Only a single node can be shared between the ERP rings; multiple shared nodes could result in a loop, if
the rings that are configured on shared nodes have common protected VLANS.

So your result is expected. Use one ERP ring as adviced and everything will be OK.
Eizens

Hi, how many node it's possible include in a single ring topology ?

By default in a single ring you can have 16 nodes.
1 single node can participate in a maximum of 8 rings.

Thank you very much.

Hello, i have attach a image with a topology network.
It's possible create this configuration or some loop might be created ?
Thank you in advance for your help ?

Simone

the previous post with the attached refers to 6855 and 9700E devices with ERP version one and each ring transport the same vlan