Help needed in ACFE exam...?
Posted: 15 Nov 2011 04:27
1>During CMM failure,secondry CMM
- pulls the ARP table from all the NI's
- flushes the ARP table for all the NI's
- pulls L3 LPM from one of the NI's and mark it as old
-none of the above
2> when a packet with an unknown destination MAC address is received on an NI which of the following occurs
- A request is sent to the CMM
- the packet is flooded out every port in the switch
- a request is sent to other NI's asking if they know about the MAC address
- ALl of the above
3> source learning can be distribute amongst each NI (true or false)
4> omniswitch 6850 ideal for
- brach office
- core
- work group
- mid size/large entrprise
5> traffic is passed at wirerate in the 6850 family ? true / false
6> All omniswitches run on common operating system (true or false )
7> wht is the purpose of raising the priority of bridge ?
- a higher priority allows for reduced convergence time
- determine a more preferred route through the network
- allows an administrator to determine which port will be the root bridge
- allows an administrator to determine which port will be the root port
8> omnichannel is standard and can be used between omniswitch and other vendor product ( true /false)
9> AN omniswitch R6, all router port MAC address must be identical (truw or false)
10> which multicast protocol uses RIP and OSPF as routing protocol ?
- pulls the ARP table from all the NI's
- flushes the ARP table for all the NI's
- pulls L3 LPM from one of the NI's and mark it as old
-none of the above
2> when a packet with an unknown destination MAC address is received on an NI which of the following occurs
- A request is sent to the CMM
- the packet is flooded out every port in the switch
- a request is sent to other NI's asking if they know about the MAC address
- ALl of the above
3> source learning can be distribute amongst each NI (true or false)
4> omniswitch 6850 ideal for
- brach office
- core
- work group
- mid size/large entrprise
5> traffic is passed at wirerate in the 6850 family ? true / false
6> All omniswitches run on common operating system (true or false )
7> wht is the purpose of raising the priority of bridge ?
- a higher priority allows for reduced convergence time
- determine a more preferred route through the network
- allows an administrator to determine which port will be the root bridge
- allows an administrator to determine which port will be the root port
8> omnichannel is standard and can be used between omniswitch and other vendor product ( true /false)
9> AN omniswitch R6, all router port MAC address must be identical (truw or false)
10> which multicast protocol uses RIP and OSPF as routing protocol ?