Cristal 1 Boards Do Not get in service

[aflores]

Hello friends.

Hope everybody is fine.

I came to you with a extrange behavior of two systems with the boards of cristal 1.

I got two systems, both of them Common Hardware, with CS, GD, 1- LANx16, 1- SLI8 and 1- APA8 boards.

Both systems, the CS and the GD get in service perfectly but the SLI and APA boards did not.

I have test with Rel 7, 8, 9 and 10; and with all releases it is the same behavior, the CS and GD work fine, but any board on the cristal one get into service.

I also have plug and configure another type of boards and any of them get into service only the CS and GD.

Any suggestions will be appreciated.

Regards

AFlores

[aflores]

Finally I found a GD that was working fine.

I tested in this two systems and every is working fine. It seem that the other two GD are damage. Still it is extrange case because both GD alow ne to reload the NANflash and download the binaries with PC Instaler, let me configured and got in to service.

Regards.

AFlores