static route on omnipcx
Posted: 25 Apr 2011 06:25
I am about to have an omnipcx unit installed with 4068 and 4028 IP phones
I am proposing to install the LAN and phones on 10.10.10.0/24
The computing infrastructure will be on 172.20.208.0/20 . The main network router to the internet is a Cisco 857. I will use another (dd-wrt) router to route traffic between the 2 LANs using that router's address as the gateway on the omnipcx and configuring a static route on the Cisco for traffic to 10.10.10.0/24 to go via the other port on the dd-wrt. This will enable me to use the configuration software on my computers to connect via the LAN port of the omnipcx (? I believe it won't work on the WAN port ?) At this stage i don't need to use the WAN port of the omnipcx as we are not configuring a SIP trunk. T
If we later want to configure a SIP trunk on the omnipcx, can it also be via the LAN and router ? Alternatively, if we get a dedicated modem for the SIP trunk (say 192.168.0.1) , can static routes be set up on the omnipcx so that traffic for 172.20.208.0/24 goes via the dd-wrt router and for the SIP trunk gets routed by the omnipcx to the WAN port and on to the VOIP modem ?
thank you
I am proposing to install the LAN and phones on 10.10.10.0/24
The computing infrastructure will be on 172.20.208.0/20 . The main network router to the internet is a Cisco 857. I will use another (dd-wrt) router to route traffic between the 2 LANs using that router's address as the gateway on the omnipcx and configuring a static route on the Cisco for traffic to 10.10.10.0/24 to go via the other port on the dd-wrt. This will enable me to use the configuration software on my computers to connect via the LAN port of the omnipcx (? I believe it won't work on the WAN port ?) At this stage i don't need to use the WAN port of the omnipcx as we are not configuring a SIP trunk. T
If we later want to configure a SIP trunk on the omnipcx, can it also be via the LAN and router ? Alternatively, if we get a dedicated modem for the SIP trunk (say 192.168.0.1) , can static routes be set up on the omnipcx so that traffic for 172.20.208.0/24 goes via the dd-wrt router and for the SIP trunk gets routed by the omnipcx to the WAN port and on to the VOIP modem ?
thank you