Alcatel Unleashed

Hi,

I am trying to do performance test automatically on Alcatel box 6850-24 with our automation software.
The current image is 6.4.3.668.R01.

We are simulating 2 ERPS rings with Alcatel Switch. I have done the below configurations. Here Alcatel Switch is the RPL owner.I am using the ring port as 1/1 and 1/2 .
1/2 is RPL link.

I am sending to send tagged data traffic(vid = 300). Alcatel Switch adding the vlan id 100 and forwards the data traffic on both the port 1/1 and 1/2 in idle state where 1/2 is in blocking state.

Please find my configuration below. For topology please find the attachment. I think i am missing few configurations.

please anyone guide me on this. I am struggling for more than 3 weeks.

With Regards,
Ganga.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
ethernet-service svlan 100 name "VLAN 100"

ethernet-service svlan 200 name "VLAN 200"

ethernet-service svlan 100 nni 1/1-2 erp

ethernet-service svlan 200 nni 1/1-2 erp

ethernet-service service-name "DATA" svlan 100

ethernet-service sap 500 service-name "DATA"

ethernet-service sap 500 uni 1/4

ethernet-service sap 500 cvlan 300

erp-ring 1 port1 1/1 port2 1/2 service-vlan 200 level 2

erp-ring 1 rpl-node port 1/2

erp-ring 1 enable

--------------------------------------
-> show erp port 1/1
Legend: * - Inactive Configuration

Ring-Id : 1
Ring Port Status : forwarding,
Ring Port Type : non-rpl,
Ethoam Event : disabled,
Remote-endpoint Id : none

-> show erp port 1/2
Legend: * - Inactive Configuration

Ring-Id : 1
Ring Port Status : blocking,
Ring Port Type : rpl,
Ethoam Event : disabled,
Remote-endpoint Id : none

hello

check this setup perhaps it will help you

Cedric

Hi Ganga,

1st let me know how u did the configuration in RLAowner. since if u did the configuration on the interface level u should remove the existing vlan in the corresponding interface. here i have mention the Junifer ERPS configuration for your reference. the below configuration for two data channel. do the same as your box it will work if u have any issue call me.


Ring instances


* ring-1—Data channel [200,300]
* ring-2—Data channel [500,600]


* Customer site 1, VLAN 200 and VLAN 300
* Customer site 2, VLAN 500 and VLAN 600


* RPL owner—ring-1.
* East interface—ge-3/2/4.0.
* West interface—ge-5/2/3.0.
* Data channel for ring-1—VLAN 200, VLAN 300.
* Data channel for ring-2—VLAN 500, VLAN 600.
* Ring protection link end for ring-1—ge-3/2/4.0.


* Routing instance—vs.
* Bridge domains:
o bd100 is associated with vlan-id 100.
o bd101 is associated with vlan-id 101.
o bd200 is associated with vlan-id 200.
o bd300 is associated with vlan-id 300.
o bd500 is associated with vlan-id 500.
o bd600 is associated with vlan-id 600.