Hello all,
I hava a new GD-3 but it wont be started.
After DDR RAM 256M has been load, the next step must be Flash: 2M but a lot of strange character like as diferent bit rate between VT100 and Config port is printed.
See the attach.
GD-3 wont start
-
oliveira_Arthur
- Member
- Posts: 143
- Joined: 19 Sep 2008 22:27
- Location: Brazil
GD-3 wont start
You do not have the required permissions to view the files attached to this post.
Regards,
Arthur Oliveira
Arthur Oliveira
Re: GD-3 wont start
What was your solution?
-
mustafa.ahmad
- Member
- Posts: 253
- Joined: 27 May 2010 03:23
Re: GD-3 wont start
Maybe the GD3 board was faulty or something .. y don't u try loading its binaries again using the Omni PCX installer... maybe it will help
Regards,
Mustafa
Regards,
Mustafa
-
oliveira_Arthur
- Member
- Posts: 143
- Joined: 19 Sep 2008 22:27
- Location: Brazil
-
mustafa.ahmad
- Member
- Posts: 253
- Joined: 27 May 2010 03:23
Re: GD-3 wont start
u can try on the same old one....
