Alcatel Unleashed

If you want to make a H.323 call to a 3rd party and you have a H.323 GateKeeper you dont need to use ABB numbers to make the call unlike the documentation that says that you do.

All you have to to is register the INTIP to a gatekeeper (can check using cpl_online <cry> <cpl> then RAS and you should what it is registered to)
and put the IP trunk group in the ARS and it works.
This makes it alot easier to use them rather than having predigit then use the internal route to an ABB number that then makes the call in either GK or GW mode (IP or nomal call type).

The DOC doesn't state that using ABB is the only way to use a H.323 trunk group. Moreover it is implied that you can use it in a simmilar way to ISDN lines, the only limitation is to target one IP with it (this is the point where gatekeeper comes into picture).
Regards.