QOS Problem on OS6850 - Out of TCAM

chewiegurl · Post by **chewiegurl** » 15 Aug 2010 22:56

HI everyone! I'm new here but I need to consult on some errors encountered in OS6850. Iwas trying to configure Qos in our OS6850 switch. Configuring the groups and the conditions went perfectly fine until configuring the rule as a final step. The rule I configured was not effected and an error message was displayed "ERROR: Out of TCAM processors on 1/0(0)".

I need your help, need to interpret this error message. And suggested solutions would be very much appreciated also.

Thanks a lot!

benny · Post by **benny** » 16 Aug 2010 04:19

Please post the output of "show qos slice". Actually it would help if you could provide your full configuration.

-benny

chewiegurl · Post by **chewiegurl** » 16 Aug 2010 22:19

Hi benny,

I browsed through similar threads in this site and found this manual 2637_QoS_Design_Guidelines_OS6850_OS9000.pdf which clearly explained the QoS rules and its TCAM allocation. I was able to resolve my Qos problem then, thanks to the manual

Kudos,

Cherry