Redial Last Number

sameh · Post by **sameh** » 24 May 2010 07:26

I hope you are doing well

I Have OXO system
when i make external call and the required side are busy
i recall agin by using redial button
but that impossible
so only reply calls i can to make redial on it

please tell me how i can make redial for any calls(reply or not reply)

thank & regards

etc · Post by **etc** » 26 Jun 2010 10:21

Suppose, you have analog trunk lines. The dialling number would be stored in redial list (on analog lines): 1) - after switching to conversation (by timer); or 2) by reaching the format in Numbering/ End of Dialling table. Timer you can change in External Lines/ Protocols/ Analog trunks/ Modify/ Off-hook Simul. ... numbers.
End of dialling table is only one for whole PBX. You can have problems for fiilling in this table, if you have different format on same digits in different directions.

sameh · Post by **sameh** » 27 Jun 2010 08:39

Thank sir

I go to External Lines/ Protocols/ Analog trunks/ Modify/
But I found this parameters: off hook simul.Closed number
off hook simul.open number DEC (set)
off hook simul.open number MF (set)
off hook simul. Behind PCX
Please tell me the values for each above
Thank you

enio.eltz · Post by **enio.eltz** » 28 Jun 2010 16:28

Hi Sameh

I use ( in Brazil ) 3000 ms for each parameter.

Best regards.