Page 1 of 1
PIMPhony installation help
Posted: 11 Mar 2010 06:37
by picasso
Hi all, need advice in configuring PIMPHONY software. Which settings (IP info, port no, ext no, codec.....) i must enter while installing Pimphony software? I mean most of the settings stays default but the required settings which should be enter by installer.
thanks
Posted: 12 Mar 2010 08:53
by Maurice
Hello Picasso,
on PIMphony itself you just need to give the OXO IP@ and then choose the subscriber you want to associate PIMphony.
If you need information for your network configuration (router, firewall etc...) here some values from Alcatel Technical Communication n° 103
4.5 Alcatel-Lucent PIMPhony v6.X associated with a IP touch
4.5.1 ... to OmniPCX Office (R5.0 and higher)
Alcatel-Lucent PIMphony Wizard auto-detection of the OmniPCX Office
Protocol IP sources Ports sources IP destinations Ports destinations
UDP PC IP@ * 224.0.1.111 8889 to 8888
Alcatel-Lucent PIMphony signalization (HTTPS mode) wizard configurable
Protocol IP sources Ports sources IP destinations Ports destinations
TCP PC IP@ * CPU IP@ 443 or 30443
TCP CPU IP@ 443 or 30443 PC IP@ *
Alcatel-Lucent PIMphony signalization (HTTP mode) wizard configurable
Protocol IP sources Ports sources IP destinations Ports destinations
TCP PC IP@ * CPU IP@ 80 or 8894
TCP CPU IP@ 80 or 8894 PC IP@ *
Regards,
Maurice