NDDI and Paging
Posted: 16 Nov 2004 16:47
Anyone here have experience connecting a NDDI to a Telcor II Paging system?
Have a friend who did it.
I will ask him to join the forum.
Alcatel Unleashed
The #1 Worldwide board for technical support on Alcatel-Lucent Voice & Data gear.
https://alcatelunleashed.com/
NDDI and Paging
Page 1 of 1
Posted: 17 Nov 2004 09:36
Posted: 18 Nov 2004 07:02
Not to that particluar system, but it is generally the same for most.
What are you stuck with in particluar?
What are you stuck with in particluar?
Posted: 18 Nov 2004 10:13
I setup the analog trunk per Alcatel doc on Paging. The Trunk will connect to the Paging system, but after couple of seconds (and I can adjusted this by manipulate the Trunk Category). But in all cases the trunk will go busy then HS.
I don't have any info on the paging system one has to be a dealer with Telcor to access techincal information). But I believe it only support Direct Tie-line trunk paging, and I don't think ALcatel support Direct Tie-line paging.
I don't have any info on the paging system one has to be a dealer with Telcor to access techincal information). But I believe it only support Direct Tie-line trunk paging, and I don't think ALcatel support Direct Tie-line paging.
Posted: 19 Nov 2004 12:54
Hi ..
Okay, I spoke to my friend:
The paging system provides tone.
He has a direct tie from NDDI board to the system.
He created a prefixe for this special trunk.
He allows only certain peoplen to access this trunk.
And everything works well
Any informations you want ?
Okay, I spoke to my friend:
The paging system provides tone.
He has a direct tie from NDDI board to the system.
He created a prefixe for this special trunk.
He allows only certain peoplen to access this trunk.
And everything works well
Any informations you want ?