Page 2 of 3
Posted: 27 Jan 2010 00:16
by frank
REMOVE ALL VPN
Disable all internet interfaces but the local one
uninstall PCINSTALLER
remove directories
remove registry settings
reboot
install new release
let us know..
Posted: 27 Jan 2010 03:57
by patmul39
had to load a couple of CPU's yesterday and I thought what the heck - gice it a try and the damned thing worked!!! And to amaze me even more I had my VPN up and working, anti-virus etc. I can't understand this - and I did nothing to the machine!!
Posted: 27 Jan 2010 04:10
by murraya
sure you didn't reboot
I have always found it best to make sure the PC is connected to the network before starting the installer so that the NIC is up as I have had issues in the past when I run the installer then connect the NIC.
Posted: 27 Jan 2010 05:20
by OXE_4400
frank wrote:REMOVE ALL VPN
Disable all internet interfaces but the local one
uninstall PCINSTALLER
remove directories
remove registry settings
reboot
install new release
let us know..
Everything mentioned was done, a lot of PC restarts, different versions. I have opened SR.
I am going to buy new faster HDD and reinstall PC...
Will try to install PC installer version 2.26, it should appear with R9.1 patch 13.
Posted: 27 Jan 2010 09:38
by frank
ok, let us know..
Posted: 27 Jan 2010 12:30
by patmul39
murraya wrote:sure you didn't reboot
I have always found it best to make sure the PC is connected to the network before starting the installer so that the NIC is up as I have had issues in the past when I run the installer then connect the NIC.
No reboots! It just worked!
Posted: 04 Feb 2010 22:54
by zaenuddin
I have the same problem , i think the problem is from installer at R 9.1 ,because with the old release ( 9.0 ) working Fine .
for others you can try to install new PC Installer from release 9.1 ( i160512) ,and you will know the real problem,you cannot uninstall it.
Please let us know if some one have solve this problem ?
Thanks
Posted: 05 Feb 2010 04:23
by alex
zaenuddin wrote:
Please let us know if some one have solve this problem ?
Strange. I did a couple of times install/uninstall of 2.25-pre when was playing with my new HP 6730b notebook and Windows 7 Pro x86.
There were no problem at all. Of course you should switch off Windows firewall to load SW but except that everything was OK.
So I think it is PC HW+OS setup specific problem.
Posted: 08 Feb 2010 02:54
by OXE_4400
ALU support provided solution for problem. It was changed value in registry HKEY_LOCAL_ MACHINE\SYSTEM\CurrentControlSet\Control\FileSystem\NtfsDisable8dot3NameCreation to 1.
It should be 0. Changed back, uninstalled PC installer, restarted PC, installed even newest 2.26 version and everything OK.
Posted: 14 Jun 2010 14:39
by aalmanzar
I tried installing the PC installer 2.22, 2.24, and even 2.26. when I double click on the set up shortcut nothing happens. It was working fine when I had 2.11 but because I need it now I UN-installed 2.11 to install 2.26, now my PC is not allowing me to install the PC installer software. Any ideas???
